I'd taken off just after lunch time and headed up route 83 from our camp ten miles north of Seeley lake. I'd not gone too awful far when I rolled up on an opportunity I couldn't pass up...
|*My Favorite Forms of Horsepower*|
A small band of horses was pastured along the highway, so I swung around and caught a photo of the two modes of transportation that have had the biggest impact on this old busters life. Most of 'em had run off down to a river bottom below... these few hung around for a portrait.
From four feet to two wheels... A motorcycle always struck me as the right sort of vehicle for a horseman.
I kinda like the picture, even if the front wheel IS on backwards! :)
Then it was spin 'er around again and twist the throttle for Kalispell. I'd been advised that since I had a near to gone tire anyway (at least half way through the wear bars) I should keep it under a hundred. I obliged and rarely broke 80. :)
I wonder why they do call 'em wear bars? They sure don't slow down the wear rate any when you get to 'em!
Well... I got to Penco Motorsports in Kalispell about an hour before the appointed time, and reported in. I was surprised when they went right to work on it and had the new tire on before I was even supposed to be there!
How often do you get THAT sort of service?
Before you ask... yes, THIS time I checked to make sure the tire was turning the right direction before I climbed back on...
I got a lil' closer and checked some more...
I even got down on my knees and checked it for sure and for certain...
Yep... everything is just like it's supposed to be... well... except for all the road gouges I've picked up on that one time polished aluminum wheel... Damned Ol' thing is starting to get as many dings as I carry around...
Now... just to say it... Apache Yamaha down on Camelback in Phoenix... has declined to even respond to my attempts to contact them over the past week about their Installing the wheel backwards when their shop mounted the tires for me.
So considering their lack of care for their reputation... I'd take your tires to Ridenow... or some other shop, since Apache doesn't seem to be too awful concerned about the safety of their customers... At least not enough to even open a conversation once the customers card has been debited. :)
That's ok... I got better things to do with my time than worry about the faults of another company that'll one day seal its own fate.
I needed to make a "quick" run across Kalispell to run some errands...and guess what? As small as Kalispell might be... it's still not a town your gonna do a "quick" run in at rush hour. ;) But I finally made the run both directions... got out of town and headed south...
... right into another rush hour... this one of the wildlife variety. The service manager at Penco had warned me to be watchful running that road at sunset... the deer on it he claimed were BAD.
and I gotta agree with him... rolling along at 80 or so...there were quite a few! Along with three turkeys. :) But I have a technique... if you go fast enough... you're past 'em before they even have the time to get out on the pavement! :)
|*Hwy 83 between Seeley Lake and Kalispell Montana*|
That's a nice road... not so many straight runs, and lots of nice sweeping bends under a Wide Montana Sky... with the Mountains, lakes, horses and meadows all along the ride.
Well, I was curious how the thing would handle with the tire on there right. It had been an improvement over the Metzler when it was new... but as the tread got thinner... it started really losing its grip...
It's a lot nicer running home... with a tire that isn't handling "funny"... As my confidence grew, and the manufacturing scum got scrubbed off... my momentum picked up... and life was good again. :)
The new tire with the tread running the right direction :)
I failed to find the angle to catch a good picture and this one really doesn't show it well... but the tread over the center is mostly gone.
Only there enough to be visible. Not especially a shiny condition for guys that tend to ride ( in spite of wild claims of quiet and sensible cruising) at rates of locomotion that can capture the attention of certain motorized members of soh-sigh-uh-tees rule enforcement division...
You can see in a spot or two the shadow on the tire where it was badly cupping on that left side... and just flat wearing "odd"...
Oh well... lesson learned... Check all work... no matter how Pro you think the guy who did the work might be.
Now... I'll be curious to see if the mileage on this tire changes with it spinning correctly...
In the meantime... I'm hoping to get back to racking up more miles in the next year than what I spun off in the last... I kinda let life get in the way of LIVING... and that's not a real tolerable sitchy-ashun...
Grab Your Handles and Ride
Nice looking ride you've got there - even if the front wheel IS on backwards. Enjoy your new tires.
Ahhh scrubbing in new tires on a nice peaceful road. Perfect. Glad they treated you so well in Kalispell.
I enjoyed your first pic showing the different kinds of horsepower.
Canajun; I looked, but that they weren't around on the run back to get a proper pitture ;)
Trobairitz; A bike, a sunny Montana sky and an open road? It doesn't get a whole lot better. I have no idea why your description didn't come to me... Horsepower has such a better sound than transportation! I went back and edited a caption to correct that. ;)
My buddy and I stayed in a wall tent at the Seeley Lake Motor Lodge a couple of weeks ago. As we were getting ready to head north towards Kalispell on 83, we has at lest 2 people warn us of deer on that stretch of road. We saw quite a few that morning. A couple of them were standing on the road as we approached. It reminded me a lot of home here in northern WI.
I'm glad you replaced the tire, the old one in the pics was looking pretty bad. Keep an eye on the air pressure and you should get plenty of miles from it!
Post a Comment